How can I deal with the issue of my iPhone5 – Black screen after swap, constant “bong” noise?

Hi! I’ve had the exact issue, and it was so frustrating. Here’s what I did: First, I performed a hard reset by holding down the home and power buttons for 10 seconds until the Apple logo appeared. This sometimes resolves temporary glitches. Second, I checked the proximity sensor, as dust or misalignment can cause the constant ‘bong’ noise. Finally, I ensured the replacement parts were high-quality. It’s essential to use reliable components to avoid these kinds of problems. Good luck!

Oh, I’ve been down this rabbit hole with my iPhone 5. Here’s what helped: Sometimes the replacement screen itself might be a defective piece. Testing with another screen can rule this out. Also, check for any signs of motherboard damage. In rare cases, components could be compromised during the screen swap. Lastly, holding down both the home and power buttons until the Apple logo appears can surprisingly reset the device and might fix it.

Been there, done that with my iPhone 5. Here’s a rundown that resolved my issue with the black screen and constant ‘bong’ sound: 1. Make sure the ribbon cables aren’t pinched or damaged. 2. Ensuring the backlight connector is free from errors or misalignment can save your sanity. 3. Position the device in a dust-free zone while working on it. Dust can wreak havoc. 4. If the phone was left to rest and it worked, sometimes internal capacitors need to discharge fully before reconnecting everything.

Hey there! I totally get your frustration. I dealt with this exact same problem on my iPhone 5 after changing the screen. My rescue came from these steps: 1. Always ground yourself using an anti-static wrist strap. Electrostatic discharge is an off-radar issue that can ruin sensitive components. 2. Ensure your iPhone’s software is updated. Sometimes anomalies fix themselves after an update. 3. Don’t over-tighten internal screws; pressure points could be distorting the connections. 4. Sometimes it’s best to get a technician. They have tools and expertise that DIYers typically don’t. Worked for me!

I’m sorry to hear about your iPhone 5 issues. I ran into a similar struggle and found some solutions: 1. Check the LCD connector for secure placement, avoiding any pinches or damage. 2. Use a static-free workspace to minimize electrical interference. 3. If all else fails, restore your phone to factory settings. It sometimes irons out hidden software wrinkles. 4. Lastly, try another screen swap, if possible, to rule out a defective part.

I’ve experienced this exact problem with my iPhone 5 after a screen replacement. The solution for me was fairly straightforward. Here are the steps you might want to try: 1. Double-check all display connectors to see if they are properly connected. Even a slight misalignment can cause the black screen issue. 2. Disconnect the battery for 20 seconds, then reconnect it and try powering on the device again. 3. Look closely for any signs of damage on the motherboard or connectors, as they can easily be harmed during the screen replacement process. 4. If you’re still stuck, backing up your data and performing a restore via iTunes can sometimes resolve underlying software issues causing the problem.