Why does the calibration screen on my switch not take input from my Joycon?

1. Ensure there’s no Bluetooth interference from other devices like smartphones, tablets, or nearby wireless networks. 2. Try performing a hard reset on your Switch by holding down the power button for 15 seconds and then turning it back on. 3. Consider using the Joycons in wired mode by attaching them directly to the Switch console if you usually use them detached. This can sometimes help bypass wireless connection issues that affect the calibration process. 4. If the problem remains unresolved, testing the Joycons with another Switch console can help isolate whether the problem is with the controllers or the console itself.

To diagnose the problem where the calibration screen on your Switch doesn’t accept input from your Joycon, you might need to check for any physical damage. Examine if there are any visible damages or issues with the Joycon’s analog stick. Sometimes, even minor physical issues could cause input recognition problems. Testing with a different Joycon, if available, can help pinpoint whether it’s an issue with the controller or the console.

You could be facing a software glitch with your Switch. Try turning off the Switch completely, holding down the power button for three seconds, then selecting ‘Power Options’ and ‘Turn Off.’ After it’s completely powered down, wait a few seconds and turn it back on. This simple reset can sometimes clear up odd issues like the one you’re experiencing. If the problem continues, I suggest doing a factory reset as a last resort, but make sure to back up your data first.

One thing that’s frequently overlooked is that the calibration screen might be unresponsive due to an accumulation of software bugs. I recommend performing a soft reset of the system through the power menu. If that doesn’t change anything, recalibrating the controllers via a different system setup or through an updated firmware patch might resolve any underlying connectivity bugs.

When I encountered an issue similar to this, I checked the battery life on my Joycon controllers. Sometimes, if the battery is low, it can cause the controllers to behave erratically. Make sure both Joycons are fully charged. Try using them again when they’ve got a full charge, which could resolve the unresponsive calibration screen issue.

1. First, check if there are any firmware updates for your Joycon controllers. Go to System Settings > Controllers and Sensors > Update Controllers. This can often resolve issues with input recognition. 2. Next, try resetting your Joycon. Press and hold the small sync button on the side of the Joycon for about 15 seconds until the lights start flashing. Then, reconnect the Joycon to your Switch and attempt the calibration process again. 3. If that doesn’t work, test the Joycon on another Switch console if you have access to one. This will help determine if the issue is with the Joycon itself or your Switch. 4. You might also want to clean the rails of the Joycon and the Switch. Dirt or debris in the rail can interfere with the connection. 5. Finally, if the issue persists, you may need to contact Nintendo support for further assistance or consider getting the Joycon repaired or replaced.

If your calibration screen is not registering input from your Joycon, you may be dealing with interference from wireless devices. Make sure your Switch is not in close proximity to other Bluetooth or wireless devices that could be causing interference. Sometimes, simply moving to a different room or decluttering wireless traffic around your gaming area can make a big difference.

I had a similar issue where my Joycon seemed to work fine during normal gameplay but wouldn’t register on the calibration screen. In my situation, it turned out to be an issue with the Joycon’s connection to the Switch. I resolved it by pressing the sync button on the Joycon until it started flashing, then reconnecting it. Sometimes, reestablishing the connection can fix these types of issues.