How do I go about resetting my ink absorber on my home printer?
How do I go about resetting my ink absorber on my home printer?
I have been receiving error messages on my printer indicating that the ink absorber is full. This issue has been disrupting my printing tasks and causing significant inconvenience. The messages seem to imply that I need to reset the ink absorber to continue using my printer efficiently. However, I am not entirely sure what an ink absorber is or how to address this issue. I am concerned about potentially damaging my printer if I attempt to reset it incorrectly. It would be really helpful to understand what steps I need to take to safely reset my ink absorber and why this problem might be occurring in the first place.
5 Answers
In my experience, resetting the ink absorber wasn’t an intuitive task. Here’s how I finally managed: 1. Initial Setup: Switch off the printer and press the ‘Power’ button. 2. Service Mode: Simultaneously press and release the ‘Resume’ button while holding the ‘Power’ button. 3. Navigating Options: Release the ‘Power’ button after a few seconds. Press the ‘Resume’ button a few times (the exact number depends on the printer model). 4. Reset Process: Continue pressing the ‘Resume’ button until the light blinks counter resets. Power off and then restart the printer. This method varied slightly from other instructions I found online. It’s critical to have your model’s manual handy.
When I faced a similar issue with resetting my ink absorber, I went through several different forums before finding an effective solution. Here is what I learned: 1. Safety First: Unplug the printer and handle everything gently. 2. Access the Printer Menu: – Hold the ‘Stop/Reset’ button and press the ‘Power’ button. – Release the ‘Stop/Reset’ button but keep holding the ‘Power’ button. 3. Enter Service Mode: – While holding the ‘Power’ button, press the ‘Stop/Reset’ button twice. – Release both buttons and wait for the green light. 4. Resetting: – Press the ‘Stop/Reset’ button four times to enter reset mode. – Turn the printer off and on. I also cleaned the absorber pads to be on the safe side. Be prepared for some potential mess!
I had the same issue recently and here’s a concise walkthrough of what worked for me: 1. Preparation: Turn off the printer and open the front panel. 2. Buttons Sequence: – Press and hold the ‘Resume’ button. – Press and hold the ‘Power’ button until the power light appears green. – Release the ‘Resume’ button while holding the ‘Power’ button, then hit the ‘Resume’ button twice before releasing both. 3. Final Steps: – Wait for the power light to blink. – Press ‘Resume’ four times, then power off and back on. This process varied slightly from what I read online but eventually worked to reset my ink absorber.
When troubleshooting my ink absorber resetting, I found that the problem lies in the ink absorber becoming saturated over time. To deal with it, the procedure I followed included: Switching off and unplugging my printer to ensure there’s no power. Disassembling the printer carefully to locate the ink absorber. Using gloves, I removed the absorber and washed it with water until the ink rinsed away. After drying completely, I reassembled everything. The final step was performing a system reset to clear the error message. While this process took some time, it’s quite straightforward if you’re cautious.
To reset the ink absorber on your printer, you must follow these steps: 1. Turn off the printer. 2. Hold down the ‘Resume’ button while pressing the ‘Power’ button. 3. Keep the ‘Power’ button pressed and release the ‘Resume’ button. 4. Press the ‘Resume’ button twice, then release both buttons completely. 5. The printer will enter a special mode (you might see the lights blinking). 6. Press the ‘Resume’ button four times. 7. Turn off the printer and then turn it back on. These steps should reset the ink absorber counter. You might want to refer to your printer’s manual for more detailed instructions as these might vary depending on the model.